[. . . ] 23 en Safety and warning information Before you switch ON the appliance Please read the operating and installation instructions carefully. They contain important information on how to install, use and maintain the appliance. The manufacturer is not liable for any damage caused by users ignoring the information and warnings contained in the instructions for use. Important information when using the appliance S Never use electrical appliances inside the appliance (e. [. . . ] - Freshness of the drinking water (if water has not been dispensed for a long time, the water may have a stale" taste. Taste and odour of the water may be improved by installing the enclosed water filter. The enclosed water filter will filter only particles out of the supply water, not bacteria or microbes. Do not use fragile receptacles for dispensing water or ice ć risk of injury from broken glass!Note: The ice and water dispenser will not function unless the appliance is connected to the power supply. Note: - Remove the receptacle from the dispenser pad when it is approx. Ice in the discharge may cause the receptacle to overflow or block the discharge. - After switching over from dispensing ice cubes to crushed ice, the disĆ penser may still contain whole ice cubes or pieces of ice cube. When switching on your new appliance, observe the following When the appliance has been conĆ nected, there are still air bubbles in the lines. Run off drinking water and pour away until water can be dispensed without bubbles. When using the ice maker for the first time, do not use the first 30Ć40 ice cubes for reasons of hygiene. 32 en Removing and cleaning the water collecting tray Spilled water collects in the water collecting tray. The water collecting tray can be emptied and cleaned by pulling it out. Disconnecting the ice cube maker If ice cubes are not to be dispensed for longer than 1 week (e. Holiday), temporarily disconnect the ice cube maker to prevent the ice cubes from freezing together. Changing the filter S Caution: unplug the appliance or switch off the circuit breaker. Removing and cleaning the ice cube container If ice cubes have not been dispensed for a prolonged period, they will shrink, have a stale taste and stick together. S Thoroughly dry the container and screw conveyor to prevent new ice cubes from sticking. Switching on the ice cube maker again: S Press Ice maker" lock button. Inserting the ice cube container S Push the ice cube container all the way back onto the supports until it locks into position. S Carefully turn the filter 90º antiĆclockĆ wise, and pull it out. S Remove the new filter from its packĆ aging and remove the protective cap. [. . . ] Freezer compartment door is deeper: If the previous steps for aligning the door are not adequate: S Remove the base panel. 41 en Switching on the appliance Switch on the appliance according to the enclosed operating instructions. Disconnecting the appliance Disconnect the appliance according to the enclosed operating instructions. If the appliance is to be disconnected or stored at temperatures below freezing point, empty the water tank for the drinking water dispenser. [. . . ]